当面の実際のテストを一致させるために、JPexamのCiscoの350-021問題集の技術者はずべての変化によって常に問題と解答をアップデートしています。それに我々はいつもユーザーからのフィードバックを受け付け、アドバイスの一部をフルに活用していますから、完璧なJPexamのCiscoの350-021問題集を取得しました。JPexamはそれを通じていつまでも最高の品質を持っています。
Ciscoの350-021の認定試験は当面いろいろな認証試験で最も価値がある試験の一つです。最近の数十年間で、コンピュータ科学の教育は世界各地の数多くの注目を得られています。Ciscoの350-021の認定試験はIT情報技術領域の欠くことができない一部ですから、IT領域の人々はこの試験認証に合格することを通じて自分自身の知識を増加して、他の分野で突破します。JPexamのCiscoの350-021認定試験の問題と解答はそういう人たちのニーズを答えるために研究した成果です。この試験に合格することがたやすいことではないですから、適切なショートカットを選択するのは成功することの必要です。JPexamはあなたの成功を助けるために存在しているのですから、JPexamを選ぶということは成功を選ぶのことと等しいです。JPexamが提供した問題と解答はIT領域のエリートたちが研究と実践を通じて開発されて、十年間過ぎのIT認証経験を持っています。
JPexamのCiscoの350-021試験資料を買いたかったら、弊社は最も良いサービスと最も高品質な製品を提供します。弊社の認証試験のソフトウェアはもうベンダーとサードパーティーの認可を取り、大量なIT技術専門家たちがいますから、お客さんのニーズを答えるためにアウトラインに基づいてシリーズの製品を開発して、お客様の大量の要求を満たすことを保障します。Ciscoの350-021試験資料は最高の専門技術の内容を持っていますから、関連する知識の専門家と学者は研究する材料として利用することができます。弊社が提供した製品は一部の無料試用資料がありますから、購入する前にあなたのテストの質と適用性を保証します。
試験番号：350-021問題集
試験科目：CCIE SP Cable Qualification Exam
最近更新時間：2014-02-10
問題と解答：全399問
100％の返金保証。1年間の無料アップデート。
JPexamの助けのもとで君は大量のお金と時間を费やさなくても復楽にCiscoの350-021認定試験に合格のは大丈夫でしょう。ソフトの問題集はJPexamが実際問題によって、テストの問題と解答を分析して出来上がりました。JPexamが提供したCiscoの350-021の問題集は真実の試験に緊密な相似性があります。
JPexamはIT認定試験の350-021問題集を提供して皆さんを助けるウエブサイトです。JPexamは先輩の経験を生かして暦年の試験の材料を編集することを通して、最高の350-021問題集を作成しました。問題集に含まれているものは実際試験の問題を全部カバーすることができますから、あなたが一回で成功することを保証できます。
購入前にお試し,私たちの試験の質問と回答のいずれかの無料サンプルをダウンロード：http://www.jpexam.com/350-021_exam.html
NO.1 For communications systems what describes the over-all health of the system?
A. Bit-Error-Rate (BER)
B. Synchronous Optical NETwork (SONET)
C. Optical Signal to Noise Ratio (OSNR)
D. None of the above
Answer: A
Cisco 350-021 350-021 350-021問題集 350-021
NO.2 A router is set to boot from flash, but cannot find boot commands in the configuration. Also, valid files
do not exist in the default flash device. The router will:
A. Boot from ROM, since there are no valid sources
B. Try to boot from the network, using a default filename
C. Terminate the boot process with an error message
D. Try to boot from the network, then boot from ROM as a backup
Answer: D
Cisco認証試験 350-021認証試験 350-021
NO.3 Cisco recommends the use of a headend-grade coaxial cable or a quad-shield coaxial cable with a
minimum of 60% + 40% braid and double foil insulation to connect the cable modem cards to the HFC
network. The center conductor must be straight and extend 1/8 inch (3.2 mm) beyond the end of the
connector, and the connector should be securely crimped to the cable. Select three recommended cable
types that can be used to connect the Cisco uBR7200 series universal broadband routers: (multiple
answer)
A. RG 58
B. RG 59
C. RG 59/U
D. RG 6
E. RG 7
Answer: BCD
Cisco過去問 350-021過去問 350-021 350-021 350-021 350-021問題集
NO.4 Given a PAL HFC and 8 MHz channel lineup in the downstream, is it possible to utilize 6 MHz DOCSIS
cable modems and signals on the network?
A. No, only 8 MHz channel spacing is available for Downstream data signals
B. Yes, as long as the 6 MHz DOCSIS signal is within a valid 8 MHz channel
C. Yes, as long as the DOCSIS signal is upconverted through a PAL upconverter
D. No, DOCSIS cannot be mixed with EuroDOCSIS in the Donwstream
E. DOCSIS must be used only in an EIA-542 channel plans
Answer: B
Cisco 350-021 350-021 350-021認定証 350-021 350-021
NO.5 What describes a technique, used to encapsulate voice (NOT data) over ATM?
A. RFC 1483
B. LANE
C. AAL-1
D. RFC 1577
Answer: C
Cisco 350-021 350-021 350-021
NO.6 A network administrator is using debug commands to check the performance of a network. What steps
can the administrator take to ensure that the "debug" will not require too much CPU, or at least that she
will not have to reboot the router to disable debug? (multiple answer)
A. Make the debug command as specific as possible
B. Use the max-time parameter of the debug command
C. In configuration mode, enter scheduler interval 15
D. Configure a loopback to channel debug traffic
Answer: AC
Cisco認定試験 350-021 350-021練習問題 350-021
NO.7 For an OC-48 signal (2.5Gb/s), what is the BER (bit error rate) if there is 1 bit error every four days?
A. 10E-12
B. 10E-13
C. 10E-14
D. 10E-15
E. 10E-16
Answer: D
Cisco 350-021 350-021認証試験 350-021
NO.8 Which are HFC cable television forward path networks aligned to provide? (multiple answer)
A. For asymmetrical gain since the downstream and upstream bandwidths are also asymmetrical
B. For unity gain with a fixed input level and varying output levels adjusted by the selection of a fixed
value attenuator and equalizer at the output stage in each of the forward amplifiers in the network
C. For unity gain with a fixed output level and varying input levels adjusted by the selection of a fixed
value attenuator & equalizer at the input stage of each of the forward amplifiers in the network
D. It is not necessary to align the forward path amplifiers since the CMTS will automatically compensate
for forward path gain discrepancies.
E. For unity gain and are level compensated by automatic gain and slope control systems utilizing RF pilot
reference carriers
Answer: CE
Cisco認定資格 350-021認定試験 350-021
NO.9 Unity gain is being used for alignment. The first amplifier from the node has 25 dB of gain and is 2000
feet away with cable loss of 1 dB per 100 feet. The node has an output of 35 dBmV at 55.25 MHz. What is
the input at the amplifier?
A. 13dBmV
B. 3dBmV
C. 15dBmV
D. 27dBmV
Answer: C
Cisco 350-021認定試験 350-021問題集
NO.10 There are two different headends with two different frequencies available sharing the same plant.
There is a -10dB cable loss to the second active in the cascade. What is the required pad for balancing
A. A 0 pad
B. A 1 pad
C. A 2 pad
D. A 3 pad
E. A 4 pad
F. A 5 pad
Answer: F
Cisco過去問 350-021過去問 350-021
NO.11 Upon deleting an IOS image file from flash, an execution of show flash shows the file still in flash, with
a 'D' preceding it (as shown in the exhibit). What step must be taken in order to remove the file
completely?
A. Erase the file from flash
B. Format the flash device
C. Replace the flash card - it is defective
D. Execute a squeeze command on the flash device
Answer: D
Cisco認定証 350-021 350-021問題集 350-021
NO.12 In a cable HFC plant, which devices are modulators? (multiple answer)
A. CMTS line card
B. Upconverter
C. Diplex filter
D. Set top box
E. Fiber node
Answer: AD
Cisco 350-021認定資格 350-021認定試験 350-021 350-021認証試験 350-021
NO.13 What is NOT an ATM class of service?
A. CBR
B. VBR-t
C. ABR
D. UBR
E. CAR
Answer: E
Cisco 350-021問題集 350-021 350-021認定試験 350-021参考書
NO.14 Every time a typing mistake is made at the exec prompt of a router, the message from the router
indicates a lookup is being performed. Also, there is a waiting period of several seconds before the next
command can be typed. Can this behavior be changed?
A. No, this is a built in feature of Cisco IOS? software.
B. Yes, use the no ip domain-lookup command.
C. Yes, use the no ip helper-address command.
D. Yes, use the no ip multicast helper-map command.
E. Yes, use the no exec lookup command.
Answer: B
Cisco参考書 350-021認定資格 350-021認定試験
NO.15 The name of the DOCSIS config file to download will be offered to the cable modem in what DHCP
field?
A. giaddr
B. config-filename
C. packet-filename
D. siaddr
Answer: C
Cisco 350-021 350-021
NO.16 HFC cable television return path networks are aligned to provide: (multiple answer)
A. Asymmetrical gain since the downstream and upstream bandwidths are also asymmetrical
B. Unity gain with a fixed input level and varying output levels adjusted by the selection of a fixed value
attenuator and equalizer at the output stage in each of the return amplifiers in the network
C. Unity gain with a fixed output level and varying input levels adjusted by the selection of a fixed value
attenuator and equalizer at the input stage of each of the return amplifiers in the network
D. Cable modems the ability to power range comfortably within their output power dynamic range
E. It is not necessary to align the return path amplifiers since the CMTS will automatically adjust the cable
modem transmit power levels.
Answer: BD
Cisco 350-021認定試験 350-021
NO.17 A DOCSIS 2-way data system is being designedto limit upstream traffic. Unknown modems should be
kept from using precious Upstream bandwidth. Given these requirements, it should beensured that the
DOCSIS configuration file has what set?
A. Vendor-specific information field
B. Max-cpe should be set to 1
C. CMTS authentication field should be set
D. Network Access should be set to 0
E. Downstream frequency should be set above 450 MHz
Answer: D
Cisco 350-021認定資格 350-021
NO.18 What effect will this configuration command have?
line vty 0 4
no password vtypassword
A. All telnet connections to the router will be denied.
B. Only one telnet connection at the router will be allowed at a time.
C. Virtual terminal sessions will not be able to enter enable mode.
D. Virtual terminal sessions will not be asked a user-level password.
E. It will have no effect.
Answer: A
Cisco 350-021 350-021認定資格 350-021 350-021認証試験
NO.19 If there are two different headends with two different frequencies available sharing the same plant, what
frequency will the two groups of cable modems, which are brand new, and have never been on-line, lock
on?
A. They will lock on the frequency configured on the linecard.
B. They will lock on the frequency configured on the upconverter.
C. They will lock on the first frequency they find.
D. They will lock on the lowest frequency.
E. They will lock on the last frequency remembered in ram.
Answer: C
Cisco 350-021 350-021 350-021 350-021
NO.20 What is the purpose of rate decoupling for ATM transmission?
A. It provides transparency between SONET and SDH.
B. It converts higher-speed DS3/E3 to lower-speed optical rates.
C. It processess the packing and unpacking of frames into 53-octet cells.
D. It allows lower-speed traffic on an ATM facility without causing traffic gaps.
Answer: D
Cisco問題集 350-021認定証 350-021 350-021問題集
JPexamは最新の1z0-593問題集と高品質の400-051問題と回答を提供します。JPexamのMB6-889 VCEテストエンジンとIIA-CIA-Part2試験ガイドはあなたが一回で試験に合格するのを助けることができます。高品質の642-467 PDFトレーニング教材は、あなたがより迅速かつ簡単に試験に合格することを100％保証します。試験に合格して認証資格を取るのはそのような簡単なことです。
没有评论:
发表评论